Home › ENGINE › 2GR-FE STARTING › SMART KEY SYSTEM

DTC    B2289    Key Collation Waiting Time Over

for Preparation Click here


DESCRIPTION

This DTC is output when there is a LIN communication problem between the main body ECU (instrument panel junction block) and certification ECU (smart key ECU assembly) or when there is a problem in the entry function.

HINT:
If the main body ECU (instrument panel junction block) is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored. After the main body ECU (instrument panel junction block) is replaced, perform the registration procedure for the engine immobiliser system (Click here).


DTC No.
DTC Detection Condition
Trouble Area
B2289
Either condition below is met:
  1. LIN communication is abnormal between the main body ECU (instrument panel junction block) and the certification ECU (smart key ECU assembly)
  2. The engine immobiliser system is malfunctioning
  1. Main body ECU (instrument panel junction block)
  2. Smart key system (entry)
  3. Wire harness or connector
  4. Certification ECU (smart key ECU assembly)

WIRING DIAGRAM


B177341E01


INSPECTION PROCEDURE

1.CHECK FOR DTCS
  1. Delete the DTCs (Click here).

  1. Check for DTC B2289 (Key collection waiting time over) and B2785 (Communication malfunction between ECUs connected by LIN).

    Result:
    Display (DTC output)
    Proceed to
    "DTC B2289" only
    A
    "DTC B2785" only
    B
    No DTC
    C

    HINT:
    If DTC B2785 is output, perform troubleshooting for DTC B2785 first.



B
GO TO DTC B2785 (Click here)

C
USE SYMPTOM METHOD TO CHECK (Click here)
A


2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU)


  1. Disconnect the D40 and 1E ECU connectors.


    B180496E02

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1E-7 (LIN1) - D40-10 (LIN)
    Always
    Below 1 Ω
    1E-7 (LIN1) or D40-10 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK MAIN BODY ECU OPERATION
  1. After replacing the main body ECU (instrument panel junction block) with a normally functioning ECU, check that the engine starts.

    OK:
    Engine starts normally.

    HINT:
    If the engine does not start, refer to PROBLEM SYMPTOMS TABLE of the smart key system (entry) (Room Oscillator does not Recognize Key).



NG
GO TO SMART KEY SYSTEM (ENTRY) (Click here)
OK

END (MAIN BODY ECU DEFECTIVE)