Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


If a normal system code is displayed during the DTC check, but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

HINT:
  1. The following is the troubleshooting procedure for the wireless door lock control of a vehicle with the smart key system.
  2. For the troubleshooting procedure for the wireless door lock control of a vehicle with the smart key system, refer to the wireless door lock control system (w/ Smart Key System).
  3. Inspect the fuse and relay before investigating the suspected areas shown in the table below.
  4. Use the table below to help determine the cause of a problem. The likely causes of the problem are indicated in descending order. Check each suspected area in order. Repair or replace faulty parts or perform adjustments as necessary.


WIRELESS DOOR LOCK CONTROL SYSTEM: 
Symptom
Suspected Area
See page
Only wireless control function is inoperative
Door control transmitter
Click here
Transmitter battery
Click here
Main body ECU
-
Door control receiver
-
Unlock warning switch
Click here
Wire harness or connector
-
Answer-back function does not operate normally.
Lighting system
Click here
Main body ECU
-
Wire harness or connector
-
Wireless door lock buzzer
Click here
The automatic lock function does not operate normally.
Perform the operation check
Click here
Unlock warning switch circuit
Click here
Door courtesy switch circuit
Click here
If the symptoms still occur after the above areas have been inspected and proved to be normal, replace the main body ECU (Instrument Panel junction block)
-
The illuminated entry function only does not operate.
Perform the operation check
Click here
Lighting system
Click here
If the symptoms still occur after the above area has been inspected and proved to be normal, replace the main body ECU (Instrument Panel junction block)
-
The answer back function does not operate (Hazard warning light).
Perform the operation check
Click here
Wire harness or connector
-
Turn signal flasher assembly
Click here
If the symptoms still occur after the above areas have been inspected and proved to be normal, replace the main body ECU (Instrument Panel junction block)
-