Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2799    Engine Immobiliser System Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs first.

DTC No.
DTC Detection Condition
Trouble Area
B2799
One of following conditions is met:
  1. Error in communication between ECM and transponder key ECU
  2. Error in communication lines
  3. Communication ID is different during communication with transponder key ECU
  1. Wire harness or connector
  2. ECM
  3. Transponder key ECU assembly

WIRING DIAGRAM


B151007E07


INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU is replaced, register the key and ECU communication ID (Click here).
  2. If the ECM is replaced, register the ECU communication ID (Click here).

1.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 output does not recur.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.RE-REGISTER ECU COMMUNICATION ID
  1. Re-register the ECU communication ID (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 output does not recur.



NG
Go to step 4
OK

END (PROBLEM WITH ECU COMMUNICATION ID IS DEFECTIVE) 

4.CHECK CONNECTION OF CONNECTOR
  1. Turn the ignition switch off.

  1. Check that the connectors are properly connected to the ECM and the transponder key ECU.

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTORS PROPERLY
OK


5.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)


  1. Disconnect the transponder key ECU and ECM connectors.


    B171358E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D41-12 (EFII) - D36-15 (IMO)
    Always
    Below 1 Ω
    D41-13 (EFIO) - D36-16 (IMI)
    Always
    Below 1 Ω
    D41-12 (EFII) - Body ground
    Always
    10 kΩ or higher
    D41-13 (EFIO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


7.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Click here).


NEXT


8.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2799 output does not recur.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)
OK

END (ECM IS DEFECTIVE)