Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2173/73    Vehicle Speed or Engine Speed Signal Malfunction

for Preparation Click here


DESCRIPTION

The tire pressure warning ECU receives a vehicle speed signal from the combination meter and an engine speed signal from the ECM. The tire pressure warning ECU uses these signals to detect DTCs C2121/21 to C2125/25 (No Signal from Transmitter) and DTC C2177/77 (Initialization not Completed).

DTC No.
DTC Detection Condition
Trouble Area
C2173/73
Following condition (a) or (b) is met for a total of 15 minutes:
(a) No engine speed signal while vehicle speed is 8 km/h (5 mph) or more
(b) No vehicle speed signal while engine speed is a specified value
  1. Combination meter
  2. ECM
  3. Harness or connector
  4. Tire pressure warning ECU

HINT:
This DTC is set at the same time as DTCs C2121/21 to C2124/24 are being set.


WIRING DIAGRAM


C162299E05


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU if the ECU has been replaced.

1.PERFORM SIGNAL CHECK (VEHICLE SPEED SIGNAL AND ENGINE SPEED SIGNAL)
  1. Enter the signal check mode in TEST MODE PROCEDURE (Click here).

  1. Drive the vehicle at 20 km/h (12 mph) or more for 3 seconds or more to erase DTC C2191/91.

  1. Start the engine and allow it to run at 1000 rpm for 3 seconds or more to erase DTC C2194/94.

  1. Check for test mode DTCs.
    Result 
    Result
    Proceed to
    DTCs C2191/91 and C2194/94 are erased
    A
    DTC C2191/91 is output
    B
    DTC C2194/94 is output
    C

    HINT:
    DTCs C2181/81 to C2185/85 (Transmitter ID not Received) are output at this time, but they are not related to this check.



B
GO TO DTC C2191/91 (Click here)

C
GO TO DTC C2194/94 (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)