Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the cruise control system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT


    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Check for output DTCs.

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B

      HINT:
      The hybrid vehicle control ECU of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure that there is no trouble in the CAN communication system.



    B.
    PROCEED TO "CAN COMMUNICATION SYSTEM" (Click here)
    A


    4.CHECK INDICATOR LIGHT

      NEXT


      5.CHECK FOR DTC*
      1. Check for DTCs (Click here).

      2. Clear the DTCs (Click here).

      3. Recheck for DTCs (Click here).

      4. Result:
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      B.
      GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
      A


      6.PROBLEM SYMPTOMS TABLE
      1. Refer to problem symptoms table (Click here).


      2. Result:

        Result
        Proceed to
        There is no applicable symptom in the table
        A
        There is an applicable symptom in the table
        B



      B.
      GO TO STEP 8
      A


      7.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Terminals of ECU (Click here).

      2. Data List / Active Test (Click here).


      NEXT


      8.REPAIR OR REPLACE

        NEXT


        9.CONFIRMATION TEST

          NEXT

          END