Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer and confirm the problem (Click here).


    NEXT


    3.CHECK DTC AND FREEZE FRAME DATA*
    1. Check and record DTCs and Freeze Frame Data.

    2. Clear the DTCs and Freeze Frame Data (Click here for DTC Check/Clear, and Click here for Freeze Frame Data).

    3. Reconfirm the DTCs.

      1. Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data (Click here for DTC Check/Clear, and Click here for Freeze Frame Data).

        HINT:
        1. When DTCs indicating CAN communication system malfunctions are output, repair the CAN communication system before repairing each corresponding sensor (Click here).
        2. If any of DTCs U0123/62, U0124/95, U0126/63, and U0293/59 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (Click here).


        Result:

        Result
        Proceed to
        DTC is output
        A
        DTC is not output (Problem symptom does not occur)
        B
        DTC is not output (Problem symptom occurs)
        C



    B.
    GO TO STEP 5

    C.
    GO TO STEP 6
    A


    4.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart (Click here).


    NEXT

    GO TO STEP 7


    5.SYMPTOM SIMULATION
    1. Proceed to Diagnosis System (Click here).


    NEXT


    6.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).


    NEXT


    7.CIRCUIT INSPECTION*

      NEXT


      8.IDENTIFICATION OF PROBLEM

        NEXT


        9.REPAIR OR REPLACEMENT

          NEXT


          10.CONFIRMATION TEST*

            NEXT

            END