Electronically Controlled Brake System
Symptom
| Suspected Area
| See page
|
ABS, BA and/or EBD does not operate
| Use a chassis dynamometer, etc. to check the electronically controlled brake system operation.
| -
|
Check the DTC again and make sure that the normal system code is output.
|
Click here
|
IG power source circuit
|
Click here
|
Front speed sensor circuit
|
Click here
|
Rear speed sensor circuit
|
Click here
|
Check the brake actuator assembly with the Techstream. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leak.
|
Click here
|
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU.
|
Click here
|
ABS, BA and/or EBD does not operate efficiently
| Check the DTC again and make sure that the normal system code is output.
|
Click here
|
Front speed sensor circuit
|
Click here
|
Rear speed sensor circuit
|
Click here
|
Check the brake actuator assembly with the Techstream. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leak.
|
Click here
|
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU.
|
Click here
|
ABS warning light abnormal (Remains on)
| ABS warning light circuit
|
Click here
|
Skid control ECU
|
Click here
|
ABS warning light abnormal (Does not come on)
| ABS warning light circuit
|
Click here
|
Skid control ECU
|
Click here
|
Brake warning light / red (malfunction) abnormal (Remains on)
| Brake fluid level warning switch circuit
|
Click here
|
Brake warning light / red (malfunction) circuit
|
Click here
|
Skid control ECU
|
Click here
|
Brake warning light / red (malfunction) abnormal (Does not come on)
| Brake warning light / red (malfunction) circuit
|
Click here
|
Skid control ECU
|
Click here
|
VSC and/or TRAC does not operate
| Check that traction control has not operated by carrying out diagnosis.
| -
|
Check the DTC again and make sure that the normal system code is output.
|
Click here
|
IG power source circuit
|
Click here
|
Check the hydraulic circuit for leak.
| -
|
Front speed sensor circuit
|
Click here
|
Rear speed sensor circuit
|
Click here
|
Yaw rate and acceleration sensor circuit
|
Click here
|
Steering angle sensor circuit
|
Click here
|
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU.
|
Click here
|
Brake warning light / yellow (minor malfunction) abnormal (Remains on)
| Brake warning light / yellow (minor malfunction) circuit
|
Click here
|
Skid control ECU
|
Click here
|
Brake warning light / yellow (minor malfunction) abnormal (Does not come on)
| Brake warning light / yellow (minor malfunction) circuit
|
Click here
|
Skid control ECU
|
Click here
|
Slip indicator light abnormal (Remains on)
| Slip indicator light circuit
|
Click here
|
Skid control ECU
|
Click here
|
Slip indicator light abnormal (Does not come on)
| Slip indicator light circuit
|
Click here
|
Skid control ECU
|
Click here
|
DTC check cannot be done
| Check the DTC again and make sure that the normal system code is output.
|
Click here
|
TC and CG terminal circuit
|
Click here
|
If the symptoms still occur even after the above circuit in suspected areas has been inspected and proved to be normal, replace the skid control ECU.
|
Click here
|
Sensor check cannot be done
| TS and CG terminal circuit
|
Click here
|
Skid control ECU
|
Click here
|
Skid control buzzer abnormal
| Skid control buzzer circuit
|
Click here
|
Skid control ECU
|
Click here
|