Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    B1473/73    A/C Inverter Start-up Signal System Malfunction

for Preparation Click here


DESCRIPTION

The inverter activation signal is sent to the compressor with motor assembly from the hybrid vehicle control ECU. Compressor control is stopped and the DTC is output if there is an open or short in the signal circuit.

DTC No.
DTC Detection Condition
Trouble Area
B1473/73
Open or short in A/C inverter start-up signal system circuit
  1. Harness or connector between hybrid vehicle control ECU and compressor with motor assembly
  2. Compressor with motor assembly
  3. Hybrid control system
  4. CAN communication system

WIRING DIAGRAM


E158954E03


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Using the Techstream, check if the CAN communication system is functioning normally.

    Result:
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK FOR DTC
  1. Check if DTCs for the air conditioning system and the hybrid control system are output using the Techstream.

    Result:

    Result
    Proceed to
    Only DTC B1473 is output
    A
    DTCs B1473 and P3108 are output simultaneously (B1498 is not output)
    DTCs B1473 and B1498 are output simultaneously (P3108 is not output)
    B
    DTCs B1473, B1498 and P3108 are output simultaneously
    DTCs other than P3108 are output for hybrid control system
    C



B
GO TO DTC B1498/98 (Click here)

C
GO TO HYBRID CONTROL SYSTEM (Click here)
A


3.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - COMPRESSOR WITH MOTOR ASSEMBLY)
  1. Disconnect the connector from the hybrid vehicle control ECU.



    E160222E06
  1. Disconnect the connector from the compressor with motor assembly.

    CAUTION:
    Do not disconnect the connector on the high-voltage side.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    B2-18 (STB) - B48-4 (STB1)
    Always
    Below 1 Ω
    B2-18 (STB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT COMPRESSOR WITH MOTOR ASSEMBLY
  1. Reconnect the connector to the compressor with motor assembly.



    E160221E03
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    (Symbols)
    Switch Condition
    Specified Condition
    B2-18 (STB) - Body ground
    Power switch on (IG)
    11 to 14 V
    B2-18 (STB) - Body ground
    Power switch off
    Below 1 V



NG
REPLACE COMPRESSOR WITH MOTOR ASSEMBLY (Click here)
OK

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)