REAR WHEEL ALIGNMENT > ADJUSTMENT |
| 1. INSPECT TIRES |
Inspect the tires (Click here).
| 2. MEASURE VEHICLE HEIGHT |
Bounce the vehicle up and down at the corners to stabilize the suspension.
![]() |
Measure the vehicle height.
| Model | Front A - B | Rear C - D |
| HV (E-4WD) | 117.6 mm (4.63 in.) | 31.7 mm (1.25 in.) |
| 3. INSPECT TOE-IN |
![]() |
| Item | Specified Condition |
| Toe-in (E-4WD) (total) | C + D: 0°8' +/- 0°12' (0.14° +/- 0.2°) B - A: 3.5 +/- 2.0 mm (0.14 +/- 0.08 in.) |
| 4. ADJUST TOE-IN |
![]() |
Measure the distance between each wheel disc and the center of the toe-adjusting cam, and then confirm that left and right distances are the same.
Loosen the toe-adjust cam set nuts.
Turn the adjust cams by an equal amount to adjust toe-in.
Tighten the toe-adjust cam set nuts.
| 5. INSPECT CAMBER |
| - | E-4WD | Right-left difference |
| Camber | -0°33' +/- 45' (-0.55° +/- 0.75°) | 45' (0.75°) or less |
| 6. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION |
| 10. CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION |