TIRE PRESSURE WARNING VALVE AND TRANSMITTER > INSTALLATION |
| 1. INSTALL TIRE PRESSURE WARNING VALVE AND TRANSMITTER |
![]() |
Insert the tire pressure warning valve and transmitter into the valve installation hole. Insert it from the inside of the rim so that the printed surface can be seen.
![]() |
Install the washer on the tire pressure warning valve and transmitter from the rim side and tighten the nut.
![]() |
Set the wheel disc to the mounting machine and install the lower tire bead. Position the main body of the tire pressure warning valve and transmitter in the shaded area shown in the illustration.
Install the upper bead.
After the tire is inflated, the valve nut may be loose. Retighten the nut to the specified torque and then check for air leaks with soapy water.
| 2. INSTALL FRONT WHEEL |
| 3. INSTALL REAR WHEEL |
| 4. INSTALL GRAND SPARE TIRE (w/ Grand Spare Tire) |
| 5. INSPECT TIRES |
| 6. REGISTER TRANSMITTER ID |
| 7. INSPECT TIRE PRESSURE WARNING SYSTEM |