Home › BODY › ENGINE HOOD / DOOR › FUEL LID OPENER SYSTEM

FUEL LID OPENER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the fuel lid opener system.
  2. The Techstream should be used in step 4 and 6.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

      1. The following 5 items are important points in the problem analysis:

        What
        Vehicle model, system name
        When
        Date, time, occurrence frequency
        Where
        Road conditions
        Under what conditions?
        Driving conditions, weather conditions
        How did it happen?
        Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT


    4.CHECK FOR DTCs (SFI SYSTEM)
    1. Check for DTCs and note any codes that are output (Click here).

    2. Delete the DTCs.

    3. Recheck for DTCs. Try to duplicate the DTCs (SFI system) by simulating the symptoms indicated by DTCs.

      Result:

      Result
      Proceed to
      SFI system DTC output recurs
      A
      (Click here)
      DTC output does not recur
      B



    A.
    GO TO SFI SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)
    B


    5.PROBLEM SYMPTOMS TABLE

      Result:

      Result
      Proceed to
      Fault is listed in problem symptoms table
      A
      Fault is not listed in problem symptoms table
      B



    A.
    GO TO STEP 7
    B


    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. DATA LIST / ACTIVE TEST (Click here)

    2. TERMINAL OF ECU (Click here)

    3. OPERATION CHECK (Click here)


    NEXT


    7.ADJUSTMENT, REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END