Home › HYBRID SYSTEM · P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P3137-348    Collision Sensor Low Input

DTC    P3138-349    Collision Sensor High Input

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU monitors the connection status of the No.1 circuit breaker sensor signal (collision signal) line. If the ECU detects a malfunction, it will alert the driver.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3137
348
GND short in No. 1 circuit breaker sensor circuit
  1. Wire harness or connector
  2. No. 1 circuit breaker sensor
  3. Hybrid vehicle control ECU
P3138
349
Open or +B short in No. 1 circuit breaker sensor circuit

WIRING DIAGRAM


A174406E05


INSPECTION PROCEDURE

1.CHECK HYBRID VEHICLE CONTROL ECU (VOLTAGE CHECK)
  1. Turn the power switch on (IG).



    A174222E23
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    B1-34 (AS1G) - B1-27 (AS1)
    Power switch on (IG)
    2.3 to 3.1 V



NG
Go to step 4
OK


2.CLEAR DTC (HV)
  1. Connect the Techstream to the DLC3.

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Clear DTCs and freeze frame data.


NEXT


3.CHECK DTC OUTPUT (HV)
  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P3137-348 and P3138-349 are output.
    A
    P3137-348 and P3138-349 are not output.
    B



B
CHECK FOR INTERMITTENT PROBLEMS (Click here)
A

REPAIR HYBRID VEHICLE CONTROL ECU (Click here)  

4.CHECK NO. 1 CIRCUIT BREAKER SENSOR
  1. Turn the power switch off.

  1. Disconnect the No. 1 circuit breaker sensor connector.



    A112781E10
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B51-1 (SIF-) - B51-2 (SIF+)
    68°F (20°C)
    0.65 to 1.0 kΩ



NG
REPLACE NO.1 CIRCUIT BREAKER SENSOR (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR