Home › Engine / Hybrid System › 2GR-FE (INTAKE / EXHAUST) › INTAKE AIR CONTROL VALVE(for ACIS) › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019666 2GR-FE INTAKE / EXHAUST _0109812 INTAKE AIR CONTROL VALVE(for ACIS) G

2GR-FE INTAKE / EXHAUST  INTAKE AIR CONTROL VALVE(for ACIS)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT INTAKE AIR CONTROL VALVE (for ACIS)

a.

When using the GTS:

i.

Remove the V-bank cover sub-assembly.

Click hereEngine / Hybrid System>2GR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL


ii.

Connect the GTS to the DLC3.


iii.

Turn the ignition switch to ON.


iv.

Turn the GTS on.


v.

Enter the following menus: Powertrain / Engine / Active Test / Activate the VSV for Intake Control.

Powertrain > Engine > Active Test
Tester Display
Activate the VSV for Intake Control
50004 234 3

vi.

Make sure that a "click" sound is heard from the intake air control valve (for ACIS) when current flows.

If the intake air control valve (for ACIS) does not operate, check the ACIS control circuit.

Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>P0660


vii.

Install the V-bank cover sub-assembly.

Click hereEngine / Hybrid System>2GR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION



b.

When not using the GTS:

i.

Remove the V-bank cover sub-assembly.

Click hereEngine / Hybrid System>2GR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL


ii.

Disconnect the intake air control valve (for ACIS) connector.


iii.
A103684

Apply battery voltage between terminals 1 (+) and 2 (-) of the intake air control valve (for ACIS). Check that a "click" sound is heard from the intake air control valve (for ACIS).

If the result is not as specified, replace the intake air surge tank assembly.


iv.

Install the V-bank cover sub-assembly.

Click hereEngine / Hybrid System>2GR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION