45470
1.INSTALL TIE ROD ASSEMBLY LH
| *a | Matchmark |
Install the lock nut and tie rod assembly LH to the steering gear assembly until the matchmarks are aligned.
After adjusting the toe-in, tighten the lock nut.
45460
2.INSTALL TIE ROD ASSEMBLY RH
Perform the same procedure as for the LH side.
3.TEMPORARILY INSTALL STEERING LINK ASSEMBLY
Temporarily install the steering link assembly to the vehicle body.
Use wire or an equivalent tool to secure the steering link assembly.
51100G
4.INSTALL FRONT FRAME ASSEMBLY
5.INSTALL STEERING LINK ASSEMBLY
Install the steering link assembly to the front frame assembly with the 2 bolts and 2 nuts.
Make sure to tighten the bolts starting from the steering link assembly pinion shaft side.
Keep the nut from rotating while turning the bolt because the nut has its own stopper.
6.INSTALL FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY
Install the front stabilizer bar with front stabilizer link assembly to the front frame assembly.
48829A
7.INSTALL FRONT NO. 1 STABILIZER BRACKET LH
48824A
8.INSTALL FRONT NO. 1 STABILIZER BRACKET RH
Perform the same procedure as for the LH side.
48810
9.INSTALL FRONT STABILIZER LINK ASSEMBLY LH
48820B
10.INSTALL FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
45470
11.CONNECT TIE ROD ASSEMBLY LH
Connect the tie rod assembly LH to the steering knuckle with the nut.
Do not damage the ball joint dust cover.
Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
Install a new cotter pin.
45460
12.CONNECT TIE ROD ASSEMBLY RH
Perform the same procedure as for the LH side.
45220
13.CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY
| *a | Matchmark |
Align the matchmarks on the steering intermediate shaft assembly and steering link assembly.
Connect the steering intermediate shaft assembly to the steering link assembly.
Install a new bolt.
51442
14.INSTALL NO. 2 ENGINE UNDER COVER
15.INSTALL FRONT WHEELS
16.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
17.INSPECT STEERING WHEEL CENTER POINT