1.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55701J
2.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
for LHD: Click hereSuspension>FRONT SUSPENSION>FRONT SHOCK ABSORBER>REMOVAL
for RHD: Click hereSuspension>FRONT SUSPENSION>FRONT SHOCK ABSORBER>REMOVAL
3. OPERATION CHECK
Slide the clip and disconnect the air tube from the vacuum pump assembly.
| *a | Vacuum Gauge |
| *b | Plug |
Connect the hose of the vacuum gauge to the vacuum pump assembly.
Start the engine and warm it up for more than 2 minutes.
With the engine idling, check the vacuum of the vacuum pump assembly.
More than 86.7 kPa (650 mmHg, 25.6 in.Hg)
If the result is not as specified, replace the vacuum pump assembly.
Remove the vacuum gauge from the vacuum pump assembly.
Connect the air tube to the vacuum pump assembly, and slide the clip to secure it.
55701J
4.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
for LHD: Click hereSuspension>FRONT SUSPENSION>FRONT SHOCK ABSORBER>INSTALLATION
for RHD: Click hereSuspension>FRONT SUSPENSION>FRONT SHOCK ABSORBER>INSTALLATION
5.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY