1. FUEL PUMP ASSEMBLY OPERATION
Check fuel pressure.
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset.
| Active Test Display |
|---|
| Control the Target Fuel Pressure Offset |
| Data List Display |
|---|
| Fuel Pressure (High) |
Select the Data List item: Fuel Pressure (High).
Check that the fuel pressure fluctuates when the target fuel pressure changes.
The target fuel pressure operation decreases the target fuel pressure by 12.5% or increases the target fuel pressure by 24.8%.
If the result is not as specified, replace the fuel pump assembly or fuel delivery pipe with sensor assembly LH (fuel pressure sensor).
Check operating sound.
Remove the front wiper motor and link assembly.
Click hereVehicle Exterior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL
Remove the outer cowl top panel sub-assembly (for LHD).
Click hereSuspension>FRONT SUSPENSION>FRONT SHOCK ABSORBER>REMOVAL
Remove the outer cowl top panel sub-assembly (for RHD).
Click hereSuspension>FRONT SUSPENSION>FRONT SHOCK ABSORBER>REMOVAL
Start the engine.
Using a sound scope, check the operating sound of the fuel pump assembly.
If no sound can be heard, check the fuel pump assembly, wire harness and ECM.
Stop the engine.
Install the outer cowl top panel sub-assembly (for LHD).
Click hereSuspension>FRONT SUSPENSION>FRONT SHOCK ABSORBER>INSTALLATION
Install the outer cowl top panel sub-assembly (for RHD).
Click hereSuspension>FRONT SUSPENSION>FRONT SHOCK ABSORBER>INSTALLATION
Install the front wiper motor and link assembly.
Click hereVehicle Exterior>WIPER / WASHER>FRONT WIPER MOTOR>INSTALLATION