1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. DISCHARGE FUEL SYSTEM PRESSURE
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
17111
4.REMOVE INTAKE MANIFOLD
51442
5.REMOVE NO. 2 ENGINE UNDER COVER
23214A
6.REMOVE FUEL PUMP PROTECTOR
Disengage the clamp to disconnect the fuel tube sub-assembly from the fuel pump protector.
Remove the 2 bolts and fuel pump protector from the cylinder head sub-assembly.
7.DISCONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY
Disengage the clamp and disconnect the No. 2 fuel tube sub-assembly from the fuel pump assembly.
Click hereEngine / Hybrid System>2GR-FKS FUEL>FUEL SYSTEM>PRECAUTION
23881B
8.REMOVE FUEL HOSE BRACKET
Remove the bolt and fuel hose bracket from the cylinder head cover sub-assembly.
23801P
9.REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY
Using a 17 mm union nut wrench, loosen the 2 union nuts of the No. 1 fuel pipe sub-assembly.
Loosen the 2 bolts of the fuel pump assembly.
Remove the No. 1 fuel pipe sub-assembly from the fuel delivery pipe RH and fuel pump assembly.
23100X
10.REMOVE FUEL PUMP ASSEMBLY
Disconnect the fuel pump assembly connector.
Remove the 2 bolts, fuel pump assembly and fuel pump lifter guide from the cylinder head cover sub-assembly.
Remove the O-ring from the fuel pump assembly.
Remove the fuel pump lifter assembly from the fuel pump lifter housing.
Remove the fuel pump spacer gasket from the cylinder head cover sub-assembly.