Home › Engine / Hybrid System › 2GR-FKS LUBRICATION › OIL LEVEL SENSOR › from 2016.11
RM3160E _51 Engine / Hybrid System _060162 2GR-FKS LUBRICATION _0299638 OIL LEVEL SENSOR A

2GR-FKS LUBRICATION  OIL LEVEL SENSOR  INSTALLATION  


PROCEDURE

Hide 30500 1.SUPPORT AUTOMATIC TRANSAXLE ASSEMBLY (When Using the Engine Support Bridge)

a.
A399033

Set an engine lifter.

NOTICE:

Make sure that there is clearance between the automatic transaxle assembly and engine lifter.



Hide 89491 2.INSTALL ENGINE OIL LEVEL SENSOR

a.

Install the engine oil level sensor to the oil pan sub-assembly with the 2 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Install a new clip to the engine oil level sensor.


Hide 15104 3.INSTALL OIL STRAINER SUB-ASSEMBLY

Hide 12102A 4.INSTALL NO. 2 OIL PAN SUB-ASSEMBLY

Hide 51100G 6.INSTALL FRONT FRAME ASSEMBLY (When Using the Engine Support Bridge)

Hide 7.ADD ENGINE OIL (When Using the Engine Support Bridge)

Hide 8.INSPECT OIL LEAK (When Using the Engine Support Bridge)

Hide 9.REMOVE ENGINE ASSEMBLY FROM ENGINE STAND (When Not Using the Engine Support Bridge)