Home › Engine / Hybrid System › 1AR-FE STARTING › STARTER › from 2016.11
RM3160E _51 Engine / Hybrid System _019678 1AR-FE STARTING _0105667 STARTER A

1AR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53299D 3.REMOVE RADIATOR SIDE DEFLECTOR SEAL LH

Hide 53298E 4.REMOVE RADIATOR SIDE SEAL RH

Hide 53295E 5.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 12601B 6.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17750A 7.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 17705 8.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 17801 9.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17701 10.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 28100 12.REMOVE STARTER ASSEMBLY

a.
A207669

Open the terminal cap.


b.

Remove the nut and disconnect terminal 30.


c.

Disconnect the starter assembly connector.


d.
A207670

Type A:

i.

Remove the 2 bolts and starter assembly.



e.
A395133

Type B:

i.

Remove the 2 nuts and the starter assembly.


ii.

Using an E8 "TORX" socket wrench, remove the 2 stud bolts from the automatic transaxle assembly.