Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.11
RM3160E _54 Brake _019692 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0106374 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1203  ECM Communication Circuit Malfunction  


DESCRIPTION

This circuit is used to send TRC and VSC operation information from the skid control ECU (brake actuator assembly) to the ECM, and engine control information from the ECM to the skid control ECU (brake actuator assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1203 ECM Communication Circuit Malfunction Either of the following is detected:
1.

Engine and drive source that are sent from the ECM do not match the ones of the skid control ECU (brake actuator assembly).

2.

No stored information for engine and drive source.


·

The wrong ECU was installed

·

Skid control ECU (brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.CHECK PART NUMBER (ECM)
a.

Check that the proper ECM is installed.

OK:

Proper ECM is installed.



b.

Check if the ECM was replaced before the DTC was stored.

OK:

ECM was not replaced.



Result:
Proceed to
OK
NG



OK

2.CHECK PART NUMBER (BRAKE ACTUATOR ASSEMBLY)

NG

2.CHECK PART NUMBER (BRAKE ACTUATOR ASSEMBLY)
a.

Check that a proper skid control ECU (brake actuator assembly) is installed.

OK:

Proper skid control ECU (brake actuator assembly) is installed.



b.

Check if the skid control ECU (brake actuator assembly) had been replaced before the DTC was recorded.

OK:

Skid control ECU (brake actuator assembly) had not been replaced.



Result:
Result Proceed to
OK A
NG (The skid control ECU (brake actuator assembly) had been replaced.) B
NG (A proper skid control ECU (brake actuator assembly) is not installed.) C



A

3.CLEAR AND STORE SYSTEM INFORMATION

B

PERFORM ZERO POINT CALIBRATION AND STORE SYSTEM INFORMATION OF YAW RATE AND ACCELERATION SENSOR

C

3.CLEAR AND STORE SYSTEM INFORMATION

NEXT

4.RECONFIRM DTC
4.RECONFIRM DTC
a.

Clear the DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105

b.

Turn the ignition switch off.


c.

Turn the ignition switch to ON.


d.

Check if the same DTC is output.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTC C1203 is not output. A
DTC C1203 is output. B



A

B