Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door)
RM37A0E _59 Vehicle Exterior _086899 WINDOW / GLASS _0416693 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 85720E 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

NOTICE:

The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.


a.

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 2.INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

Hide 68104 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67408E 4.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Hide 68152C 5.INSTALL REAR DOOR GLASS RUN

Hide 67842E 6.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 67225A 7.INSTALL QUARTER WINDOW UPPER STOP

Hide 68174A 8.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

Hide 67872 9.CONNECT REAR DOOR WEATHERSTRIP

a.

Connect the rear door weatherstrip.


Hide 67604 10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 69278C 11.INSTALL REAR DOOR INSIDE HANDLE BEZEL

Hide 12.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Hide 13.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 58441L 14.INSTALL BATTERY SERVICE HOLE COVER (for HV Model)

Hide 15.INITIALIZE POWER WINDOW CONTROL SYSTEM