Home › Suspension › REAR SUSPENSION › REAR TRAILING ARM
RM37A0E _53 Suspension _086866 REAR SUSPENSION _0417442 REAR TRAILING ARM A

REAR SUSPENSION  REAR TRAILING ARM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear trailing arm assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear wheel alignment adjustment
for HV Model

Perform "Calibration".


·

DTCs are stored

·

ABS warning light illuminates

·

Brake system warning light (yellow indicator) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
for Gasoline Model
1.

Perform "Reset Memory".

2.

Perform "Calibration".


·

VSC is disabled or malfunctions

·

DTCs are output

·

Slip indicator light illuminates

·

ABS warning light illuminates


(Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Rear television camera assembly optical axis (Back camera position setting) Parking Assist Monitor System (Click here)
·

Parking assist ECU initialization

·

Adjust steering angle


Panoramic View Monitor System (Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 48738 2.REMOVE REAR SUSPENSION ARM COVER

Hide 890C0A 3.SEPARATE NO. 2 PARKING BRAKE WIRE ASSEMBLY

Hide 48780E 4.REMOVE REAR TRAILING ARM ASSEMBLY

a.
C427746C01
1.938,1.729 2.188,1.729 false 1.385,1.438 2.188,1.438 true 2.24,1.365 2.552,1.521 0.313,0.156 10 false *a 2.26,1.646 2.573,1.802 0.313,0.156 10 false *b
*a Wooden Block
*b Transmission Jack


Using a transmission jack and a wooden block, support the rear No. 2 suspension arm assembly.

NOTICE:
·

When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

·

Make sure to perform this operation with the vehicle kept as low as possible.




b.
C426721

Remove the 2 bolts and separate the rear lower shock absorber bracket sub-assembly from the rear axle carrier sub-assembly.


c.
C426720

Remove the 4 bolts, 2 washers and rear trailing arm assembly.


d.
C426721

Temporarily install the rear lower shock absorber bracket sub-assembly to the rear axle carrier sub-assembly with the 2 bolts.