Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
48780E
1.INSTALL REAR TRAILING ARM ASSEMBLY
Using a transmission jack and a wooden block, support the rear No. 2 suspension arm assembly.
When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
Make sure to perform this operation with the vehicle kept as low as possible.
Remove the 2 bolts and separate the rear lower shock absorber bracket sub-assembly from the rear axle carrier sub-assembly.
Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts (A) and 2 washers.
Install the rear trailing arm assembly to the vehicle with the 2 bolts (B).
Install the rear lower shock absorber bracket sub-assembly to the rear axle carrier sub-assembly with the 2 bolts.
890C0A
2.INSTALL NO. 2 PARKING BRAKE WIRE ASSEMBLY
for 2WD: Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE CARRIER (for 2WD)>INSTALLATION
for 4WD/AWD: Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE CARRIER (for 4WD/AWD)>INSTALLATION
48738
3.INSTALL REAR SUSPENSION ARM COVER
4.INSTALL REAR WHEEL
5.INSPECT AND ADJUST REAR WHEEL ALIGNMENT