Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB (for 2WD) › 2020.02–2020.11
RM37A0E _52 Drivetrain _086863 AXLE AND DIFFERENTIAL _0417447 REAR AXLE HUB(for 2WD) A

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for 2WD)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When removing or installing the rear disc brake cylinder assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C13DB00, C13DC00, C13DD00, C13DE00, C140000 and/or C140A00 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this procedure.

·

While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:
121 N*m (1234 kgf*cm, 89 ft.*lbf)


Hide 2.INSPECT REAR AXLE HUB BEARING LOOSENESS

Hide 42431 4.INSTALL REAR DISC

Hide 5.INSTALL REAR DISC BRAKE CYLINDER MOUNTING WITH BRAKE PAD

Hide 47850 6.INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY

Hide 890C0A 7.CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

a.

Connect the No. 2 parking brake wire assembly connector to the rear axle hub and bearing assembly.


b.

Connect the No. 2 parking brake wire assembly connector to the parking brake actuator assembly.


Hide 48738 8.INSTALL REAR SUSPENSION ARM COVER

Hide 9.INSTALL REAR WHEEL

Hide 10.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the reservoir level switch connector.


b.

Install the brake master cylinder reservoir assembly to the reservoir bracket with the bolt and nut.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


c.

Engage the clamp to install the wire harness to the brake master cylinder reservoir assembly.


d.

Connect the cable to the negative (-) auxiliary battery terminal.

Click hereGeneral>MAINTENANCE>A25A-FXS, A25B-FXS AUXILIARY BATTERY>INSTALLATION


e.

Turn the ignition switch to ON (READY).


f.

Depress the brake pedal and release it.