Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Rear Television Camera) › 2020.02–2020.11
RM37A0E _59 Vehicle Exterior _086901 WIPER / WASHER _0417566 WASHER NOZZLE(for Rear Television Camera) A

WIPER / WASHER  WASHER NOZZLE(for Rear Television Camera)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during camera cleaner nozzle assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Rear television camera assembly*
·

Parking assist monitor system initialization

·

Television camera assembly optical axis (Back camera position setting)


Parking Assist Monitor System (Click here)
Rear television camera view adjustment Panoramic View Monitor System (Click here)
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, radiator grille sub-assembly or front bumper assembly

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


Television camera view adjustment

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Rear television camera assembly*
·

Parking assist monitor system initialization

·

Television camera assembly optical axis (Back camera position setting)


Parking Assist Monitor System (Click here)
Rear television camera view adjustment Panoramic View Monitor System (Click here)
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, radiator grille sub-assembly or front bumper assembly

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


Television camera view adjustment

PROCEDURE

Hide 67848E 1.REMOVE BACK DOOR SERVICE HOLE COVER LH

Hide 67847 2.REMOVE BACK DOOR SERVICE HOLE COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 64780A 3.REMOVE BACK DOOR TRIM PANEL ASSEMBLY

Hide 4.REMOVE TELEVISION CAMERA ASSEMBLY WITH NOZZLE

Hide 867F0 5.REMOVE CAMERA CLEANER NOZZLE ASSEMBLY

a.
E431213C01
1.635,0.667 2.375,0.469 true 2.448,0.365 2.76,0.521 0.313,0.156 10 false *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the camera cleaner nozzle assembly as shown in the illustration.