Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM37A0E _58 Vehicle Interior _086884 DOOR LOCK _0417744 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.


Hide 69780B 2.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

a.
B563697C01
0,0 0,0 false
V113147

Install in this Direction


Install the rear door inside locking cable assembly as shown in the illustration.


Hide 69740D 3.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

a.
B563698C01
0,0 0,0 false
V113147

Install in this Direction


Install the rear door lock remote control cable assembly as shown in the illustration.


Hide 69038A 4.INSTALL REAR DOOR LOCK COVER SUB-ASSEMBLY

a.
B563699C01
0,0 0,0 false
V113147

Install in this Direction


Engage the 2 claws as shown in the illustration.


b.
B563700C01
0,0 0,0 false

Engage the 2 claws to install the rear door lock cover sub-assembly as shown in the illustration.


Hide 69060A 5.INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY

NOTICE:
·

When reusing a removed rear door lock with motor assembly, replace the door lock wiring harness seal with a new one.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.

·

Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the rear door lock with motor assembly.



a.

Apply MP grease to the sliding parts of the rear door lock with motor assembly.


b.

When reusing the rear door lock with motor assembly:

i.

Install a new door lock wiring harness seal to the rear door lock with motor assembly.



c.
B563701C01
3.021,2.948 3.021,2.729 true 2.927,2.969 3.135,3.188 0.208,0.219 10 true *a
*a Release Plate
V113147

Install in this Direction


Connect the rear door lock with motor assembly to the release plate of the rear door outside handle frame sub-assembly as shown in the illustration, and set it to the rear door panel.

HINT:

Make sure that the release plate of the rear door outside handle frame sub-assembly is securely connected to the rear door lock with motor assembly.



d.

Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 67842E 6.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 67604 7.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 69278C 8.INSTALL REAR DOOR INSIDE HANDLE BEZEL

Hide 9.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Hide 10.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 58441L 11.INSTALL BATTERY SERVICE HOLE COVER (for HV Model)

Hide 12.INITIALIZE POWER WINDOW CONTROL SYSTEM