This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
13090E
1.INSTALL CAM TIMING CONTROL MOTOR O-RING
| *a | Protrusion |
Install a new cam timing control motor O-ring to the No. 2 timing gear cover assembly with the protrusion of the cam timing control motor O-ring oriented as shown in the illustration.
13090D
2.INSTALL CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
Perform "Inspection After Repair" after removing and installing, or replacing the cam timing control motor with EDU assembly.
Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
| *a | Cutout |
Turn the cutout of the camshaft timing gear assembly eccentric shaft counterclockwise by hand, and set it to the maximum retard angle position.
If a camshaft lobe is opening a valve, the eccentric shaft will be difficult to turn.
When the cutout of the camshaft timing gear assembly eccentric shaft cannot be turned any farther, it is set to the maximum retard angle.
| *a | Joint |
| *b | Cutout |
| *c | Pin Hole |
| *d | Knock Pin |
Install the cam timing control motor with EDU assembly to the No. 2 timing gear cover assembly.
When installing, align the joints of the cam timing control motor with EDU assembly with the cutouts of the camshaft timing gear assembly eccentric shaft.
Align the pin holes of the cam timing control motor with EDU assembly with the knock pins of the No. 2 timing gear cover assembly when installing the cam timing control motor with EDU assembly.
Make sure the contact surface of the cam timing control motor with EDU assembly (the surface that contacts the No. 2 timing gear cover assembly) is free of foreign matter.
When installing the cam timing control motor with EDU assembly, do not use excessive force.
If the cam timing control motor with EDU assembly has been struck or dropped, replace it.
Do not disassemble the cam timing control motor with EDU assembly. If disassembled, replace it.
Install the 3 bolts.
Connect the cam timing control motor with EDU assembly connector.
82286A
3.INSTALL NO. 2 EARTH WIRE
4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
58441L
5.INSTALL BATTERY SERVICE HOLE COVER
6.INSPECT FOR ENGINE OIL LEAK
12601B
7.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
8.PERFORM INITIALIZATION
Perform "Inspection After Repair" after removing and installing, or replacing the cam timing control motor with EDU assembly.
Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION