The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.DRAIN ENGINE COOLANT (for Engine)
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
53295E
3.REMOVE COOL AIR INTAKE DUCT SEAL
17750A
4.REMOVE INLET AIR CLEANER ASSEMBLY
5.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
Disconnect the mass air flow meter sub-assembly connector.
Disengage the wire harness clamp.
| *a | Air Cleaner Cap Clamp |
| *b | Guide |
Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.
Disengage the 2 air cleaner cap clamps.
Disengage the 2 guides to separate the air cleaner cap sub-assembly from the air cleaner case sub-assembly.
Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.
22030
6.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
Disconnect the throttle body with motor assembly connector.
Slide the clip and disconnect the No. 5 water by-pass hose from the throttle body with motor assembly.
Using an 8 mm socket wrench, remove the 3 bolts and separate the throttle body with motor assembly from the intake manifold.
Slide the clip and disconnect the No. 6 water by-pass hose to remove the throttle body with motor assembly.
If the throttle body with motor assembly has been struck or dropped, replace it.
22271
7.REMOVE THROTTLE BODY GASKET
Remove the throttle body gasket from the intake manifold.