Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › ACTIVE CONTROL ENGINE MOUNT
RM37A0E _51 Engine / Hybrid System _086849 2GR-FKS ENGINE CONTROL _0418439 ACTIVE CONTROL ENGINE MOUNT G

2GR-FKS ENGINE CONTROL  ACTIVE CONTROL ENGINE MOUNT  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 2.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 12361 3.INSPECT FRONT ENGINE MOUNTING INSULATOR

a.
A454763

Disconnect the vacuum hose from the vacuum switching valve (for active control engine mount system).


b.
A454764

Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute.


c.

Check that there is no change in the needle movement of the vacuum pump gauge.

OK:

Vacuum pressure holds.



d.

Check that there is no fluid leakage caused by a break in the diaphragm.


e.

Connect the vacuum hose to the vacuum switching valve (for active control engine mount system).


Hide 17750A 4.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 53295E 5.INSTALL COOL AIR INTAKE DUCT SEAL