Home › Engine / Hybrid System › 2GR-FKS (STARTING) › STARTER (w/o Stop And Start System)
RM37A0E _51 Engine / Hybrid System _086857 2GR-FKS STARTING _0419969 STARTER(w/o Stop And Start System) A

2GR-FKS STARTING  STARTER(w/o Stop And Start System)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during starter assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1.REMOVE BATTERY

Hide 53295E 2.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 3.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 17700 4.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 74404B 6.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 28100 7.REMOVE STARTER ASSEMBLY

a.
A454695

Disconnect the starter assembly connector.


b.

Open the terminal cap.


c.

Remove the nut and disconnect the engine wire from the terminal 30.


d.
A454696

Type A:

i.

Remove the 2 bolts and starter assembly.



e.
A454698

Type B:

i.

Remove the 2 nuts.


ii.

Using an E8 "TORX" socket wrench, remove the 2 stud bolts and starter assembly.