Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HV BATTERY THERMISTOR
RM37A0E _51 Engine / Hybrid System _086850 HYBRID / BATTERY CONTROL _0420000 HV BATTERY THERMISTOR A

HYBRID / BATTERY CONTROL  HV BATTERY THERMISTOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hybrid battery thermistor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane control system (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Replacement of hybrid battery terminal block High voltage fuse accumulated load history reset DTCs are stored for 2WD:
(Click here)
for 4WD/AWD:
(Click here)

CAUTION:
·
A340386

Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.

for 2WD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 2WD)>PRECAUTION

for 4WD/AWD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 4WD/AWD)>PRECAUTION

·
A340358

To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.



NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide G92QC 2.REMOVE NO. 10 HV BATTERY SHIELD PANEL

Hide 3.REMOVE HV BATTERY JUNCTION BLOCK ASSEMBLY

Hide G920Q 4.REMOVE NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY

Hide 5.REMOVE NO. 6 HV BATTERY CARRIER BRACKET

Hide G920NB 6.REMOVE UPPER HV BATTERY COVER SUB-ASSEMBLY

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.
A455843

Disengage the clamp.


b.

Remove the 13 nuts and upper HV battery cover sub-assembly.


Hide G9282 7.REMOVE HYBRID BATTERY THERMISTOR

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.
A455844

Disengage the claw and remove the No. 3 hybrid battery packing from the HV battery.


b.
A455845

Disengage the 4 clamps.


c.

Disconnect the battery voltage sensor connector.


d.
A455846

Disengage the 5 clamps.


e.
A455847

Disengage the 6 claws of the hybrid battery thermistor (sensor portions) and remove the hybrid battery thermistor from the HV battery.