Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › FUSE BOX
RM37A0E _51 Engine / Hybrid System _086850 HYBRID / BATTERY CONTROL _0420009 FUSE BOX A

HYBRID / BATTERY CONTROL  FUSE BOX  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hybrid battery terminal block removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane control system (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Replacement of hybrid battery terminal block High voltage fuse accumulated load history reset DTCs are stored for 2WD:
(Click here)
for 4WD/AWD:
(Click here)

CAUTION:
·
A340386

Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.

for 2WD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 2WD)>PRECAUTION

for 4WD/AWD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 4WD/AWD)>PRECAUTION

·
A340358

To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.



NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 82111 3.DISCONNECT ENGINE ROOM MAIN WIRE

Hide 6.INSTALL CONNECTOR COVER ASSEMBLY

Hide 82111 7.CONNECT ENGINE ROOM MAIN WIRE

Hide 58510D 10.SEPARATE FRONT FLOOR CARPET ASSEMBLY

Hide 58556C 11.REMOVE REAR FLOOR SILENCER

Hide G92QC 12.REMOVE NO. 10 HV BATTERY SHIELD PANEL

Hide 821H1 13.DISCONNECT FLOOR UNDER WIRE

Hide 82161 14.DISCONNECT FLOOR WIRE

CAUTION:

Be sure to wear insulated gloves.


a.
A455564

Disengage the clamp.


b.

Disconnect the HV battery junction block assembly connector.


c.
A455542

Disconnect the electric vehicle battery plug assembly connector.


d.

Disengage the 3 clamps to disconnect the floor wire.


Hide G920Q 15.REMOVE NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY

CAUTION:

Be sure to wear insulated gloves.


a.
A455832

Remove the bolt and disconnect the electric vehicle battery plug assembly.


b.
A455873

Remove the 6 nuts and No. 1 hybrid battery shield sub-assembly.


Hide G92Z2 16.REMOVE HYBRID BATTERY TERMINAL BLOCK

CAUTION:

Be sure to wear insulated gloves.


a.
A455834

Disconnect the 2 hybrid battery terminal block connectors.

NOTICE:

Insulate the disconnected high-voltage connectors with insulating tape.



b.
A455833

Remove the nut and the hybrid battery terminal block from the HV battery.