Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM
RM37A0E _53 Suspension _086865 FRONT SUSPENSION _0420322 FRONT LOWER SUSPENSION ARM A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
Front wheel alignment adjustment
for HV Model

Perform "Calibration".


·

DTCs are stored

·

ABS warning light illuminates

·

Brake system warning light (yellow indicator) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
for Gasoline Model
1.

Perform "Reset Memory".

2.

Perform "Calibration".


·

VSC is disabled or malfunctions

·

DTCs are output

·

Slip indicator light illuminates

·

ABS warning light illuminates


(Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement.)
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Rear television camera assembly optical axis adjustment (Back camera position setting) Parking Assist Monitor System (Click here)
·

Parking assist ECU initialization

·

Adjust steering angle


Panoramic View Monitor System (Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 53852B 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

Hide 53851D 3.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 51420 5.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY (for A25A-FXS, A25B-FXS)

Hide 51444A 6.REMOVE REAR ENGINE UNDER COVER LH (for 2GR-FKS)

Hide 48069 9.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

a.
C424016

Remove the bolt and 2 nuts and separate the front lower No. 1 suspension arm sub-assembly from the front lower ball joint assembly.


b.
C424017

Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly from the front frame assembly.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.



c.

Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly.