89451A
1.INSTALL SHIFT LEVER POSITION SENSOR
Move the shift lever to N.
Clean and degrease the 2 bolt holes of the hybrid vehicle transaxle assembly.
| *a | Adhesive |
Apply adhesive to 2 or 3 threads on the ends of 2 new bolts.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
In order to ensure proper sealing of the 2 bolts, install them within 10 minutes of applying adhesive.
Temporarily install the shift lever position sensor to the hybrid vehicle transaxle assembly with the 2 bolts.
Do not reuse the shift lever position sensor if it has been dropped or subjected to a severe impact.
Do not allow moisture to adhere to the connector terminal.
Install the lock plate to the shift lever position sensor with the lock nut.
Temporarily install the control shaft lever to the shift lever position sensor.
Turn the control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.
Remove the control shaft lever from the shift lever position sensor.
| *a | Neutral Basic Line |
| *b | Indicator |
| *c | Range of Play |
Align the indicator with the neutral basic line.
The indicator of the lock plate has a certain amount of play. Align the center point of the range of play with the neutral basic line.
Tighten the 2 bolts.
Using a screwdriver with its tip wrapped with protective tape, secure the lock nut with the lock plate.
Install the control shaft lever and washer to the shift lever position sensor with the nut.
Connect the shift lever position sensor connector.
33820B
2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Engage the 2 claws to install a new clip to the transmission control cable assembly.
| *1 | Transmission Control Cable Assembly |
| *2 | No. 1 Transmission Control Cable Bracket |
| *a | Claw (A) |
| *b | Claw (B) |
Using a screwdriver, engage the 4 claws and connect the transmission control cable assembly to the No. 1 transmission control cable bracket.
Make sure that the claws (A) of the clip are securely engaged in the grooves of the bracket.
Make sure that the transmission control cable assembly is securely installed inside of the claws (B) of the clip.
Connect the transmission control cable assembly to the control shaft lever with the nut.
Before installing the transmission control cable assembly, check that the shift lever position sensor and shift lever are in N.
3.INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
17750A
4.INSTALL INLET AIR CLEANER ASSEMBLY
53295E
5.INSTALL COOL AIR INTAKE DUCT SEAL
12601B
6.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
7.INSPECT SHIFT LEVER POSITION SENSOR POSITION
8.ADJUST SHIFT LEVER POSITION SENSOR POSITION
9.INSPECT SHIFT LEVER POSITION
10.ADJUST SHIFT LEVER POSITION
51420
11.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
51441
12.INSTALL NO. 1 ENGINE UNDER COVER
53851D
13.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
53852B
14.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH