Refer to DTC C110000.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| P05DB12 | Brake Pedal Position Sensor "B" Circuit Short to Battery | The sensor output voltage 2 (SKS2) is 4.7 V or more for 0.2 seconds or more. | ·
Wire harness and connector ·
Brake pedal stroke sensor assembly |
Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| P05DB14 | Brake Pedal Position Sensor "B" Circuit Short to Ground or Open | The sensor output voltage 2 (SKS2) is less than 0.3 V for 0.2 seconds or more. | ·
Wire harness and connector ·
Brake pedal stroke sensor assembly |
Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| P05DB1F | Brake Pedal Position Sensor "B" Circuit Intermittent | The difference between the current value and previous value of the sensor output voltage 2 (SKS2) is 8.5% or more for 0.2 seconds or more. | ·
Wire harness and connector ·
Brake pedal stroke sensor assembly |
Output ECU: No. 2 skid control ECU (brake actuator assembly) |
Refer to DTC C110000.
After replacing or reinstalling the brake pedal stroke sensor assembly, perform "Calibration".
Check that the brake pedal and the brake pedal stroke sensor assembly are properly installed and that the pedal can be depressed normally.
Check and adjust the brake pedal height.
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for HV Model LHD)>ADJUSTMENT
Adjust the brake pedal stroke sensor assembly.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE PEDAL STROKE SENSOR (for LHD)>INSTALLATION
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Disconnect the A57 No. 2 skid control ECU (brake actuator assembly) connector.
Disconnect the A43 brake pedal stroke sensor assembly connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A57-10 (SKS2) - A43-1 (SKS2) | Always | Below 1 Ω |
| A57-10 (SKS2) or A43-1 (SKS2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG