Make sure to select foot mode before removing the rear cooling unit assembly.
1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
2.DRAIN ENGINE COOLANT (for Gasoline Model)
3.DRAIN ENGINE COOLANT (for HV Model)
for Engine:
Click hereGeneral>MAINTENANCE>A25A-FXS, A25B-FXS COOLANT (for Engine)>REPLACEMENT
58387B
4.REMOVE REAR FLOOR FINISH PLATE
5.REMOVE REAR NO. 2 SEAT ASSEMBLY
72137S
6.REMOVE REAR OUTER SEAT TRACK BRACKET COVER RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
67917A
7.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62331C
8.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT BELT>REAR NO. 1 SEAT OUTER BELT ASSEMBLY>REMOVAL
64712F
9.REMOVE FRONT DECK SIDE TRIM COVER RH
73360D
10.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT BELT>REAR NO. 1 SEAT OUTER BELT ASSEMBLY>REMOVAL
64714H
11.REMOVE NO. 1 DECK SIDE TRIM COVER
Use the same procedure as for the No. 2 deck side trim cover.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
73560
12.DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT BELT>REAR NO. 2 SEAT OUTER BELT ASSEMBLY>REMOVAL
88625T
13.REMOVE COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR (w/ Rear Automatic Air Conditioning System)
64974
14.REMOVE DECK TRIM POCKET COVER (for RH Side)
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
64725F
15.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side)
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
66311
16.REMOVE ROPE HOOK (for RH Side)
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
64730B
17.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
62638A
18.REMOVE QUARTER PILLAR GARNISH RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62470A
19.REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
88892Q
20.REMOVE COOLER PLATE
|
Remove in this Direction |
Disengage the 2 claws to remove the cooler plate as shown in the illustration.
87217D
21.REMOVE REAR NO. 1 SIDE AIR DUCT
|
Remove in this Direction |
Remove the rear No. 1 side air duct as shown in the illustration.
87217F
22.REMOVE REAR NO. 3 SIDE AIR DUCT
|
Remove in this Direction |
Remove the 2 clips.
Disengage the 2 claws to remove the rear No. 3 side air duct as shown in the illustration.
88840D
23.DISCONNECT NO. 2 AIR CONDITIONING ACCESSORY ASSEMBLY
Remove the spare tire.
Remove the bolt and disconnect the liquid tube.
Remove the O-ring from the liquid tube.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
Remove the bolt and disconnect the suction tube.
Remove the O-ring from the suction tube.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
Using pliers, grip the claws of the clip and slide the clip to disconnect the outlet heater water hose.
Do not apply excessive force to the outlet heater water hose.
Prepare a drain pan or cloth in case the coolant leaks.
Using pliers, grip the claws of the clip and slide the clip to disconnect the inlet heater water hose.
Do not apply excessive force to the inlet heater water hose.
Prepare a drain pan or cloth in case the coolant leaks.
87030A
24.REMOVE REAR COOLING UNIT ASSEMBLY
Remove the 2 bolts.
for Gasoline Model:
Disconnect each connector.
Disengage each clamp.
Disconnect the drain cooler hose.
Remove the 4 bolts.
Disengage the guide and remove the rear cooling unit assembly.
for HV Model:
Remove the 2 bolts.
Disengage the guide and disconnect the earth wire.
Disconnect each connector.
Disengage each clamp.
Disconnect the drain cooler hose.
Remove the 5 bolts.
Disengage the guide and remove the rear cooling unit assembly.