Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY › from 2020.11
RM37A0E _59 Vehicle Exterior _086885 DOOR / HATCH _0418596 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RHD and LHD.

·

The following procedure is for the LHD.



PROCEDURE

Hide 53630 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

a.

Pass the hood lock control cable assembly into the engine compartment.


b.

Engage the grommet.


c.

Engage each clamp to install the hood lock control cable assembly.


Hide 53601 2.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.

Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.


Hide 55606 3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 62112A 4.INSTALL COWL SIDE TRIM SUB-ASSEMBLY

Hide 67914 5.INSTALL FRONT DOOR SCUFF PLATE

Hide 53510 6.INSTALL HOOD LOCK ASSEMBLY (for LHD)

a.

Apply MP grease to the sliding areas of the hood lock assembly.


b.

Connect the hood lock control cable assembly to the hood lock assembly.


c.

Install the hood lock assembly with the 2 bolts and hood lock bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

HINT:

The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.



d.

w/ Engine Hood Courtesy Switch:

i.

Connect the connector.


ii.

Engage the clamp.



Hide 53510 7.INSTALL HOOD LOCK ASSEMBLY (for RHD)

a.

Apply MP grease to the sliding areas of the hood lock assembly.


b.

Connect the hood lock control cable assembly to the hood lock assembly.


c.

Install the hood lock assembly with the 2 bolts and hood lock bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

HINT:

The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.



d.

Connect the connector.


e.

Engage the clamp.


Hide 53295E 8.INSTALL COOL AIR INTAKE DUCT SEAL

Hide 53876A 9.INSTALL FRONT FENDER LINER

Hide 53852B 10.INSTALL FRONT WHEEL OPENING EXTENSION PAD

Hide 75086 11.INSTALL FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY

Hide 76622C 12.INSTALL FRONT FENDER MUDGUARD

Hide 13.INSTALL FRONT WHEEL

Hide 14.ADJUST HOOD SUB-ASSEMBLY