Home › Engine / Hybrid System › STOP AND START › BACKUP BOOST CONVERTER › from 2020.11
RM37A0E _51 Engine / Hybrid System _094408 STOP AND START _0452242 BACKUP BOOST CONVERTER A

STOP AND START  BACKUP BOOST CONVERTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during eco run vehicle converter assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

*2: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Battery terminal is disconnected/reconnected Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted Stop and Start System (Click here)
Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Front bumper assembly*2
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Forward/reverse Type) (Click here)
Front television camera view adjustment Panoramic View Monitor System (Click here)
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, radiator grille sub-assembly or front bumper assembly

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


Television camera view adjustment Panoramic View Monitor System (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 2.REMOVE FRONT BUMPER ASSEMBLY

Hide G92C0A 3.REMOVE ECO RUN VEHICLE CONVERTER ASSEMBLY

a.
A480188

While pushing the lock of the lock lever, move the lock lever as shown in the illustration, and them disconnect the eco run vehicle converter assembly connector.


b.
A480189

Remove the bolt, nut and eco run vehicle converter assembly.


Hide F1334 4.REMOVE NO. 1 CONVERTER CONTROL BRACKET

a.
A480190

Remove the 2 screws and No. 1 converter control bracket from the eco run vehicle converter assembly.