Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) › from 2020.11
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0421002 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C12C016  Brake System Control Module Power Supply Voltage Circuit Voltage Below Threshold  


DESCRIPTION

Refer to DTC C123D14.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>C123D14

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C12C016 Brake System Control Module Power Supply Voltage Circuit Voltage Below Threshold When the IG1 terminal voltage is less than 3 V, the IG2 terminal voltage is 9.5 V or more for 4 seconds or more.
·

Open or short in IG1 circuit

·

Improperly connected connector, deformation or corrosion of terminals

·

No. 2 skid control ECU (brake actuator assembly)


Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

Before performing troubleshooting, make sure to confirm that the auxiliary battery voltage is normal.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING

·

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (IG1 TERMINAL)
a.
C425607C08
1.49,0.479 1.927,0.729 0.438,0.25 2.51,2.792 2.365,2.219 true 1.594,0.521 2.052,0.719 0.458,0.198 10 false A57 0.135,0.135 0.49,0.5 0.354,0.365 10 false *a 2.458,2.823 2.854,3.094 0.396,0.271 10 false IG1
*a Front view of wire harness connector
(to No. 2 Skid Control ECU (Brake Actuator Assembly))


Make sure that there is no looseness at the locking part and the connecting part of the connector.

OK:

The connector is securely connected.



b.

Disconnect the A57 No. 2 skid control ECU (brake actuator assembly) connector.


c.

Check both the connector case and the terminals for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Turn the ignition switch to ON.


e.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A57-45 (IG1) - Body ground Ignition switch ON 11 to 14 V



Result:
Result Proceed to
11 to 14 V. A
Below 11 V. B



A

B

REPAIR OR REPLACE HARNESS OR CONNECTOR