The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.
The downhill assist control indicator light comes on when the downhill assist control is ready. Even if the downhill assist control switch is pressed, the downhill assist control indicator light will blink and the downhill assist control will not be activated under the following conditions:
The shift lever is in any position other than S (1st) or R.
The vehicle speed is 30 km/h (18 mph) or more.
VSC system is malfunctioning.
Temperature of the brake actuator assembly increases and the downhill assist control is temporarily canceled.
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Check the downhill assist control indicator and mode condition on the GTS changes according to downhill assist control switch operation.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Downhill Assist Control SW | Downhill assist control switch | OFF / ON | - | - |
| Tester Display |
|---|
| Downhill Assist Control SW |
| Downhill Assist Control Switch Operation | Mode Condition Display | Downhill Assist Control Indicator Light |
|---|---|---|
| Not pressed | OFF | Does not come on |
| Pressing the downhill assist control switch | ON | Comes on |
| Result | Proceed to |
|---|---|
| Indicator light and mode condition display do not change | A |
| Mode condition display is normal, but indicator light does not change | B |
| Indicator light and mode condition display are normal | C |
A
B
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the ignition switch off.
Inspect the downhill assist control switch.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>DOWNHILL ASSIST CONTROL SWITCH>INSPECTION
| Result |
|---|
| OK |
| NG |
OK
NG
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Disconnect the A39 skid control ECU (brake actuator assembly) connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A39-44 (HDCS) - P4-5 (B) | Always | Below 1 Ω |
| A39-44 (HDCS) or P4-5 (B) - Body ground | Always | 10 kΩ or higher |
| P4-2 (E) - Body ground | Always | Below 1 Ω |
| Result |
|---|
| OK |
| NG |
OK
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model RHD)>REMOVAL
NG