The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transaxle case oil seal and front drive shaft oil seal RH removal/installation are shown below.
| *a | An Object Exceeding Weight Limit of Engine Lifter |
The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
| *a | An Object Exceeding Weight Limit of Transmission Jack |
The automatic transaxle assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the transmission jack may suddenly drop.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
If the ECM has been struck or dropped, replace it.
Perform Vehicle Identification Number (VIN) or frame number registration when replacing the ECM.
Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION
1. PRECAUTION
If automatic transaxle assembly parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary.
Click hereDrivetrain>UA80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>PRECAUTION
36100
2.REMOVE TRANSFER ASSEMBLY
31105H
3.REMOVE TRANSAXLE CASE OIL SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the transaxle case oil seal from the transaxle housing.
Do not damage the front differential case or transaxle housing.
43410M
4.REMOVE FRONT DRIVE SHAFT OIL SEAL RH
Using SST, remove the front drive shaft oil seal RH from the front differential case.
Do not damage the front differential case.
43410M
5.INSTALL FRONT DRIVE SHAFT OIL SEAL RH
Coat the lip of a new front drive shaft oil seal RH with MP grease.
| *a | Depth |
Using SST and a hammer, install the front drive shaft oil seal RH to the front differential case.
21.5 to 22.5 mm (0.846 to 0.886 in.)
Make sure to install the front drive shaft oil seal RH as specified, otherwise malfunctions such as a fluid leak will occur.
Do not damage the lip of the front drive shaft oil seal RH.
31105H
6.INSTALL TRANSAXLE CASE OIL SEAL
Coat the lip of a new transaxle case oil seal with MP grease.
| *a | Depth |
Using SST and a hammer, install the transaxle case oil seal to the transaxle housing.
5.5 to 6.5 mm (0.217 to 0.256 in.)
Be sure to install the transaxle case oil seal in the correct direction.
Make sure to install the transaxle case oil seal as specified, otherwise malfunctions such as a fluid leak will occur.
Do not damage the lip of the transaxle case oil seal.
36100
7.INSTALL TRANSFER ASSEMBLY