The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear door belt moulding assembly removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
58441L
2.REMOVE BATTERY SERVICE HOLE COVER (for HV Model)
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for 2GR-FKS:
Click here
for A25A-FXS, A25B-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS, A25B-FXS AUXILIARY BATTERY>REMOVAL
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
69278C
5.REMOVE REAR DOOR INSIDE HANDLE BEZEL
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68174A
7.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
67225A
8.REMOVE QUARTER WINDOW UPPER STOP
67842E
9.REMOVE REAR DOOR SERVICE HOLE COVER
68152C
10.REMOVE REAR DOOR GLASS RUN
67872
11.DISCONNECT REAR DOOR WEATHERSTRIP
67408E
12.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
68124B
13.REMOVE REAR DOOR QUARTER WINDOW GLASS
68104
14.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
75740
15.REMOVE REAR DOOR BELT MOULDING ASSEMBLY
|
Protective Tape |
Apply protective tape around the rear door belt moulding assembly as shown in the illustration.
|
Remove in this Direction |
Disengage the 6 claws to remove the rear door belt moulding assembly as shown in the illustration.