Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model) › from 2020.11
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0420942 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model)  C050C1F  Left Rear Wheel Speed Sensor Circuit Intermittent  


DESCRIPTION

Refer to DTC C050C12.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>C050C12

DTC No. Detection Item DTC Detection Condition Trouble Area
C050C1F Left Rear Wheel Speed Sensor Circuit Intermittent Any of the following is detected:
·

When the +BS terminal voltage is 17.4 V or less, an open in the sensor signal circuit of a malfunctioning area occurs 255 times or more.

·

When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds.

·

When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation for 15 seconds or more.


·

Rear skid control sensor LH*1

·

Rear speed sensor LH (rear axle hub and bearing assembly LH)*2

·

Speed sensor installation

·

Rear speed sensor rotor LH (rear axle hub and bearing assembly LH)



*1: for AWD

*2: for 2WD


CAUTION / NOTICE / HINT

NOTICE:
·

After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>TEST MODE PROCEDURE

·

After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>TEST MODE PROCEDURE



PROCEDURE

1.CHECK VEHICLE SPECIFICATION
a.

Check the vehicle specification.


Result:
Result Proceed to
for 2WD A
for AWD B



A

2.READ VALUE USING GTS (RL WHEEL SPEED, MOMENTARY INTERRUPTION)

B

3.READ VALUE USING GTS (RL WHEEL SPEED, MOMENTARY INTERRUPTION)
2.READ VALUE USING GTS (RL WHEEL SPEED, MOMENTARY INTERRUPTION)
a.

While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>DATA LIST / ACTIVE TEST

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RL Wheel Speed Rear speed sensor LH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RL Speed Open Rear speed sensor LH open detection Normal / Under intermittent Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
-
Chassis > Brake/EPB > Data List
Tester Display
RL Wheel Speed
RL Speed Open
50003 435 16,104
OK:

The values change in accordance with the operation of the vehicle and there is no intermittent operation.


NOTICE:

Perform the above inspection before removing the sensor and connector.


HINT:
·

The rear speed sensor LH is incorporated into the rear axle hub and bearing assembly LH.

·

If the rear speed sensor LH needs to be replaced, replace the rear axle hub and bearing assembly LH.




Result:
Proceed to
OK
NG



OK

NG

REPLACE REAR AXLE HUB AND BEARING ASSEMBLY LH

3.READ VALUE USING GTS (RL WHEEL SPEED, MOMENTARY INTERRUPTION)
a.

While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>DATA LIST / ACTIVE TEST

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RL Wheel Speed Rear speed sensor LH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RL Speed Open Rear speed sensor LH open detection Normal / Under intermittent Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
-
Chassis > Brake/EPB > Data List
Tester Display
RL Wheel Speed
RL Speed Open
50003 435 16,104
OK:

The values change in accordance with the operation of the vehicle and there is no intermittent operation.


NOTICE:

Perform the above inspection before removing the sensor and connector.



Result:
Proceed to
OK
NG



OK

NG

4.CHECK REAR SKID CONTROL SENSOR LH INSTALLATION
4.CHECK REAR SKID CONTROL SENSOR LH INSTALLATION
a.
C168336C10
1.031,0.823 1.25,0.49 false 0.917,1.49 1.24,1.74 false 0.75,1.823 1.073,1.99 0.323,0.167 10 *a 2.427,1.823 2.75,1.99 0.323,0.167 10 *b 0.135,0.135 0.448,0.333 0.313,0.198 10 *1 1.292,0.313 1.625,0.521 0.333,0.208 10 *c 1.292,1.729 1.604,1.927 0.313,0.198 10 *d
*1 Rear Skid Control Sensor LH
*a Correct
*b Incorrect
*c 8.5 N*m (87 kgf*cm, 75 in.*lbf)
*d No clearance


Turn the ignition switch off.


b.

Check the rear skid control sensor LH installation.

OK:

There is no clearance between the rear skid control sensor LH and the rear axle carrier LH.

The installation bolt is tightened properly.

Torque:

8.5 N*m (87 kgf*cm, 75 in.*lbf)



Result:
Proceed to
OK
NG



OK

5.CHECK REAR SKID CONTROL SENSOR LH (CHECK FOR FOREIGN MATTER)

NG

5.CHECK REAR SKID CONTROL SENSOR LH (CHECK FOR FOREIGN MATTER)
a.

Remove the rear skid control sensor LH, and confirm that there is no foreign matter, oil or grease on the rear skid control sensor tip LH.

OK:

The rear skid control sensor tip LH is free of oil and foreign matter.


HINT:

If foreign matter of 1mm x 1mm or more is adhered to the rear skid control sensor LH, this DTC may be stored.



Result:
Proceed to
OK
NG



OK

6.CHECK REAR SPEED SENSOR ROTOR LH (CHECK FOR FOREIGN MATTER)

NG

9.CLEAN REAR SKID CONTROL SENSOR LH
6.CHECK REAR SPEED SENSOR ROTOR LH (CHECK FOR FOREIGN MATTER)
a.

Confirm that there is no foreign matter, oil or grease on the rear speed sensor rotor LH.

OK:

The rear speed sensor rotor LH is free of oil and foreign matter.


HINT:
·

If foreign matter of 1mm x 1mm or more is adhered to the rear speed sensor rotor LH, this DTC may be stored.

·

The rear speed sensor rotor LH is incorporated into the rear axle hub and bearing assembly LH.

·

If the rear speed sensor rotor LH needs to be replaced, replace it together with the rear axle hub and bearing assembly LH.




Result:
Proceed to
OK
NG



OK

REPLACE REAR SKID CONTROL SENSOR LH AND REAR SPEED SENSOR ROTOR LH

NG

7.CLEAN REAR SPEED SENSOR ROTOR LH
7.CLEAN REAR SPEED SENSOR ROTOR LH
a.

Clean the rear speed sensor rotor LH.

NOTICE:

Do not use parts cleaner when cleaning the rear speed sensor rotor LH.



Result:
Proceed to
NEXT



NEXT

8.READ VALUE USING GTS (RL WHEEL SPEED, MOMENTARY INTERRUPTION)
8.READ VALUE USING GTS (RL WHEEL SPEED, MOMENTARY INTERRUPTION)
a.

While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>DATA LIST / ACTIVE TEST

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RL Wheel Speed Rear speed sensor LH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RL Speed Open Rear speed sensor LH open detection Normal / Under intermittent Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
-
Chassis > Brake/EPB > Data List
Tester Display
RL Wheel Speed
RL Speed Open
50003 435 16,104
OK:

The values change in accordance with the operation of the vehicle and there is no intermittent operation.


NOTICE:

Perform the above inspection before removing the sensor and connector.


HINT:
·

The rear speed sensor rotor LH is incorporated into the rear axle hub and bearing assembly LH.

·

If the rear speed sensor rotor LH needs to be replaced, replace it together with the rear axle hub and bearing assembly LH.




Result:
Proceed to
OK
NG



OK

END

NG

REPLACE REAR SKID CONTROL SENSOR LH AND REAR SPEED SENSOR ROTOR LH

9.CLEAN REAR SKID CONTROL SENSOR LH
a.

Clean the rear skid control sensor LH.

NOTICE:

When cleaning the rear skid control sensor LH, make sure to clean the installation hole before installation.



Result:
Proceed to
NEXT



NEXT

10.READ VALUE USING GTS (RL WHEEL SPEED, MOMENTARY INTERRUPTION)
10.READ VALUE USING GTS (RL WHEEL SPEED, MOMENTARY INTERRUPTION)
a.

While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>DATA LIST / ACTIVE TEST

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RL Wheel Speed Rear speed sensor LH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RL Speed Open Rear speed sensor LH open detection Normal / Under intermittent Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
-
Chassis > Brake/EPB > Data List
Tester Display
RL Wheel Speed
RL Speed Open
50003 435 16,104
OK:

The values change in accordance with the operation of the vehicle and there is no intermittent operation.


NOTICE:

Perform the above inspection before removing the sensor and connector.



Result:
Proceed to
OK
NG



OK

END

NG

6.CHECK REAR SPEED SENSOR ROTOR LH (CHECK FOR FOREIGN MATTER)