The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during spiral cable sub-assembly removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
45100
2.REMOVE STEERING WHEEL ASSEMBLY
45287
3.REMOVE LOWER STEERING COLUMN COVER
45286B
4.REMOVE UPPER STEERING COLUMN COVER
5.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Do not remove/install the spiral cable with sensor sub-assembly with the auxiliary battery connected and the ignition switch ON.
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the auxiliary battery connected and the ignition switch ON.
Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Check that the front wheels are aligned facing straight ahead.
Disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector.
Disconnect the other connectors from the spiral cable with sensor sub-assembly.
|
Separate in this Direction |
Separate the wire harness from the spiral cable with sensor sub-assembly as shown in the illustration.
Disengage the claw and 2 clips to remove the spiral cable with sensor sub-assembly.
84306
6.REMOVE SPIRAL CABLE SUB-ASSEMBLY
Remove the steering sensor from the spiral cable sub-assembly only when replacing the spiral cable sub-assembly or the steering sensor.
Removing the steering sensor from the spiral cable sub-assembly without using a lock pin may result in the center position of the steering sensor becoming misaligned. Therefore, make sure to use the lock pin provided with a new spiral cable sub-assembly when removing the steering sensor from the spiral cable sub-assembly.
When replacing the steering sensor:
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL
Install the lock pin to the steering sensor.
Use the lock pin provided with a new spiral cable sub-assembly.
Do not remove the lock pin before installing the steering sensor to the spiral cable sub-assembly.
| *a | Guide |
Disengage the 6 claws and 2 pins to remove the spiral cable sub-assembly from the steering sensor.
Do not damage the pins of the spiral cable sub-assembly or guides of the steering sensor.