2008-2009 Hilux TRD · Service Manual Intercooler

Coolant

Intercooler · Vehicles built Up to Oct 2008

Versions by build date: Up to Oct 2008 From Oct 2008

REPLACE
CAUTION:
Do not remove the reserve tank cap while the system is hot. Pressurised, hot coolant and steam may be released and cause serious burns.
1. REMOVE FRONT FENDER LINER LH ( Click Here )
2. REMOVE FRONT FENDER LINER RH
HINT:
Use the same procedures described for the LH side.
3. REMOVE FRONT BUMPER ASSEMBLY ( Click Here )
4. DRAIN COOLANT
(a) Remove the reserve tank cap.
-
(b) Disconnect the coolant hose from the water pump and allow coolant to drain.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
-
(c) Flush and drain the system with clean water.
HINT:
To aid flushing the system, disconnect the upper coolant hose from the reserve tank and flush water through the intercooler. Then, blow through the hose with low air pressure to dispel the water from the intercooler.
NOTICE:
Excessive air pressure will damage the system.
-
5. ADD COOLANT
(a) Connect the coolant hose to the water pump and reserve tank, if removed, and secure with the clamp.
-
(b) Initially fill the reserve tank with Toyota Super Long Life Coolant (SLLC).
NOTICE:
Never use water as a substitute for coolant.
HINT:
The intercooler system is filled with Toyota SLLC at the factory. In order to avoid damage to the intercooler system and other technical problems, only use Toyota SLLC or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic and technology consists of a combination of low phosphates and organic acids).
-
(c) Operate the water pump. Either:
• Connect the intelligent tester to the DLC3 and select Active Test / Fuel Pump. (The water pump shares the fuel pump circuit), or
• Remove the WATER PUMP relay and apply 12V to terminal 3 of the relay block connector.
-
(d) Continue filling the system with 3 litres of coolant.
-
(e) With the pump running, the coolant level in the reserve tank should be level with the bottom of the reserve tank intake port.
HINT:
• If the coolant level is low, continue to add coolant until it is level with the bottom of the reserve tank intake port.
• With the pump not running, the level should rise slightly to the top of the intake port.
Intercooler system capacity:
3.2 Litres (3.4 US qts, 2.8 Imp. qts)
-
(f) Fit the reserve tank cap.
-
6. CHECK FOR COOLANT LEAKS ( Click Here )
7. INSTALL FRONT BUMPER ASSEMBLY ( Click Here )
8. INSTALL FRONT FENDER LINER LH ( Click Here )
9. INSTALL FRONT FENDER LINER RH
HINT:
Use the same procedures described for the LH side.
COOLANT HOSES
1. DRAIN COOLANT ( Click Here )
2. REMOVE COOLANT HOSES
(a) As required, remove the bolts and retaining clips.
-
(b) Loosen the hose clamps and remove the coolant hoses.


-
3. INSTALL COOLANT HOSES
(a) Clean the hose outlets.
-
(b) Connect the coolant hoses with the clamps, ensuring the hoses are correctly routed.
-
(c) Install the hose clips with the bolts, as required.
-
4. ADD COOLANT ( Click Here )
5. CHECK FOR COOLANT LEAKS
(a) Check for engine coolant leaks ( Click Here )
-