MANUAL TRANSMISSION ASSEMBLY > INSTALLATION |
| 1. INSTALL TRANSFER ASSEMBLY |
Install the transfer (Click here).
| 2. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY |
![]() |
Align the input shaft with the clutch disc and install the transmission to the engine.
Install the 4 bolts.
| 3. INSTALL STIFFENER PLATE |
![]() |
Install the stiffener plate RH with the 4 bolts.
Install the stiffener plate LH with the 4 bolts.
| 4. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR |
![]() |
Install the mounting insulator with the 4 bolts.
| 5. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY |
![]() |
Install the frame crossmember with the 4 bolts and 4 nuts.
Install the 4 set bolts to the rear No. 1 engine mounting insulator.
| 6. INSTALL STARTER ASSEMBLY |
Install the starter (Click here).
| 7. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY |
![]() |
Install the release cylinder with the 2 bolts.
| 8. CONNECT WIRE HARNESS |
Transmission side:
Connect the back-up light switch connector.
Transfer side:
Connect the No. 1, No. 2 and No. 3 transfer indicator switch connectors, and vehicle speed sensor connector.
| 9. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
Install the front exhaust pipe (Click here).
| 10. INSTALL REAR PROPELLER SHAFT ASSEMBLY |
Install the rear propeller shaft (Click here).
| 11. INSTALL FRONT PROPELLER SHAFT ASSEMBLY |
Install the front propeller shaft (Click here).
| 12. ADD MANUAL TRANSMISSION OIL |
![]() |
| 13. INSTALL NO. 2 ENGINE UNDER COVER |
| 14. INSTALL NO. 1 ENGINE UNDER COVER |
| 15. INSTALL TRANSFER CASE LOWER PROTECTOR |
Install the transfer case lower protector with the 4 bolts.
| 16. INSTALL TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY |
Install the transfer shift lever.
Using pliers, install the snap ring.
| 17. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY |
Cover the shift lever cap with a cloth.
Press down on the shift lever cap and rotate it clockwise to install it.
| 18. INSTALL SHIFT LEVER BOOT ASSEMBLY |
![]() |
Install the shift lever boot with the 4 screws and 2 clips.
w/o Console Box:
Install the floor carpet, front seat, front door scuff plate, etc.
| 19. INSTALL CONSOLE BOX ASSEMBLY |
![]() |
Install the console box with the 2 clips, 4 screws <F> and 2 bolts <E>.
| 20. INSTALL UPPER CONSOLE PANEL ASSEMBLY |
![]() |
Attach the 12 claws to install the console panel.
| 21. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
w/ M/T:
Twist the knob in the direction indicated by the arrow to install it.
w/ 4WD:
Twist the transfer shift lever knob in the direction indicated by the arrow to install it.
| 22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 23. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 24. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).