DTC P0489 Exhaust Gas Recirculation Control Circuit Low |
DTC P0490 Exhaust Gas Recirculation Control Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0489 | Open or short in E-VRV circuit for 5 seconds or more (1 trip detection logic) |
|
| P0490 | Open or short in E-VRV circuit for 5 seconds or more (1 trip detection logic) |
|

| 1.INSPECT VACUUM REGULATING VALVE (E-VRV) |
Inspect the vacuum regulating valve (E-VRV) (Click here).
|
| ||||
| OK | |
| 2.INSPECT VACUUM REGULATING VALVE (E-VRV) (POWER SOURCE VOLTAGE) |
![]() |
Disconnect the V1 vacuum regulating valve (E-VRV) connector.
Turn the ignition switch ON.
Measure the voltage of the wire harness side connector and body ground.
| Tester Connection | Specified Condition |
| V1-1 - Body ground | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (VACUUM REGULATING VALVE (E-VRV) - ECM) |
![]() |
Disconnect the V1 vacuum regulating valve (E-VRV) connector.
Disconnect the E7 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| V1-2 - EGR (E7-9) | Below 1 Ω |
| Tester Connection | Specified Condition |
| V1-2 or EGR (E7-9) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (VACUUM REGULATING VALVE (E-VRV) - INTEGRATION RELAY) |
![]() |
Remove the integration relay from the engine room junction block (Click here).
Disconnect the 1J integration relay connector.
Disconnect the V1 vacuum regulating valve (E-VRV) connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| 1J-5 - V1-1 | Below 1 Ω |
| Tester Connection | Specified Condition |
| 1J-5 - V1-1 | Below 1 Ω |
| 1J-5 or V1-1 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||