Home › TRANSMISSION ยท R150F / R151F MANUAL TRANSMISSION › MANUAL TRANSMISSION ASSEMBLY

MANUAL TRANSMISSION ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE CONSOLE BOX ASSEMBLY
(Click here)


3. REMOVE SHIFT LEVER BOOT ASSEMBLY


G034544E03
  1. Remove the 4 screws, 2 clips and shift lever boot.



4. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY


G021695E06
  1. Cover the shift lever cap with a cloth.

  1. Press down on the shift lever cap and rotate it counterclockwise to remove it.

  1. Pull out the shift lever.



5. REMOVE TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY


G021696E04
  1. Using needle nose pliers, remove the snap ring and pull out the shift lever.

    HINT:
    Move the transfer shift lever to the H4 position.



6. REMOVE TRANSFER CASE LOWER PROTECTOR
  1. Remove the 4 bolts and transfer case lower protector.



7. REMOVE NO. 1 ENGINE UNDER COVER


8. REMOVE NO. 2 ENGINE UNDER COVER


9. DRAIN MANUAL TRANSMISSION OIL
  1. Remove the drain plug and gasket to drain the oil.

  1. Install a new gasket and the drain plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



10. REMOVE REAR PROPELLER SHAFT ASSEMBLY
(Click here)


11. REMOVE FRONT PROPELLER SHAFT ASSEMBLY
(Click here)


12. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


13. DISCONNECT WIRE HARNESS
  1. Transmission side:
    Disconnect the back-up light switch connector.

  1. Transfer side:
    Disconnect the No. 1, No. 2 and No. 3 transfer indicator switch connectors, and vehicle speed sensor connector.



14. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY


G034223E01
  1. Remove the 2 bolts and disconnect the release cylinder.



15. REMOVE STARTER ASSEMBLY
(Click here)


16. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY


G034218E04
  1. Support the transmission rear side with a support stand.

  1. Remove the 4 set bolts of the rear No. 1 engine mounting insulator.

  1. Remove the 4 bolts, 4 nuts and frame crossmember.



17. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR


G034219E05
  1. Remove the 4 bolts and engine mounting insulator.



18. REMOVE STIFFENER PLATE


G034607E04
  1. Remove the 4 bolts and stiffener plate RH.

  1. Remove the 4 bolts and stiffener plate LH.



19. REMOVE MANUAL TRANSMISSION ASSEMBLY


C226298
  1. Using a transmission jack, support the transmission.

  1. Remove the support stand from the rear side.

  1. Remove the 5 bolts and transmission.



20. REMOVE TRANSFER ASSEMBLY
  1. Remove the 8 bolts and 2 clamps.

  1. Remove the transfer from the transmission.