PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Jun 2011 – Oct 2011
Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- NOTICE:
- When replacing the brake actuator assembly, a sensor, etc., turn the ignition switch off.
| Symptom |
Suspected Area |
See page |
| ABS, BA and/or EBD does not operate |
Check for DTCs again and make sure that the normal system code is output |
Click here
|
| IG power source circuit (low power supply voltage malfunction) |
Click here
|
|
| IG power source circuit (high power supply voltage malfunction) |
Click here
|
|
| Front speed sensor circuit (open or short malfunction) |
Click here
|
|
| Front speed sensor circuit (output malfunction) |
Click here
|
|
| Rear speed sensor circuit (open or short malfunction) |
Click here
|
|
| Rear speed sensor circuit (output malfunction) |
Click here
|
|
| for LHD: Check the brake actuator assembly with the intelligent tester (check brake actuator assembly operation using the Active Test function). If abnormal, check the hydraulic circuit for leaks. |
Click here
|
|
| for RHD: Check the brake actuator assembly with the intelligent tester (check brake actuator assembly operation using the Active Test function). If abnormal, check the hydraulic circuit for leaks. |
Click here
|
|
| for LHD: If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) |
Click here
|
|
| for RHD: If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) |
Click here
|
|
| ABS, BA and/or EBD does not operate efficiently |
Check for DTCs again and make sure that the normal system code is output |
Click here
|
| Front speed sensor circuit (open or short malfunction) |
Click here
|
|
| Front speed sensor circuit (output malfunction) |
Click here
|
|
| Rear speed sensor circuit (open or short malfunction) |
Click here
|
|
| Rear speed sensor circuit (output malfunction) |
Click here
|
|
| Stop light switch circuit |
Click here
|
|
| for LHD: Check the brake actuator assembly with the intelligent tester (check brake actuator assembly operation using the Active Test function). If abnormal, check the hydraulic circuit for leaks. |
Click here
|
|
| for RHD: Check the brake actuator assembly with the intelligent tester (check brake actuator assembly operation using the Active Test function). If abnormal, check the hydraulic circuit for leaks. |
Click here
|
|
| for LHD: If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) |
Click here
|
|
| for RHD: If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) |
Click here
|
|
| ABS sensor DTC check cannot be performed |
Check for DTCs again and make sure that the normal system code is output |
Click here
|
| TC and CG terminal circuit |
Click here
|
|
| for LHD: If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) |
Click here
|
|
| for RHD: If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) |
Click here
|
|
| ABS warning light abnormal (Remains on) |
Refer to ABS Warning Light Remains ON |
Click here
|
| ABS warning light abnormal (Does not come on) |
Refer to ABS Warning Light does not Come ON |
Click here
|
| Brake warning light abnormal (Remains on) |
Refer to Brake Warning Light Remains ON |
Click here
|
| Brake warning light abnormal (Does not come on) |
Refer to Brake Warning Light does not Come ON |
Click here
|
| VSC and/or TRC does not operate |
Check for DTCs again and make sure that the normal system code is output |
Click here
|
| IG power source circuit (low power supply voltage malfunction) |
Click here
|
|
| IG power source circuit (high power supply voltage malfunction) |
Click here
|
|
| Check the hydraulic circuit for leaks |
- |
|
| Front speed sensor circuit (open or short malfunction) |
Click here
|
|
| Front speed sensor circuit (output malfunction) |
Click here
|
|
| Rear speed sensor circuit (open or short malfunction) |
Click here
|
|
| Rear speed sensor circuit (output malfunction) |
Click here
|
|
| Yaw rate and acceleration sensor circuit (zero point malfunction) |
Click here
|
|
| Yaw rate and acceleration sensor circuit (power supply malfunction) |
Click here
|
|
| Yaw rate sensor circuit (comparison malfunction) |
Click here
|
|
| Steering angle sensor circuit (zero point malfunction) |
Click here
|
|
| Steering angle sensor circuit (output malfunction) |
Click here
|
|
| for LHD: If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) |
Click here
|
|
| for RHD: If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) |
Click here
|
|
| VSC sensor DTC check cannot be performed |
Check for DTCs again and make sure that the normal system code is output |
Click here
|
| TC and CG terminal circuit |
Click here
|
|
| for LHD: If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) |
Click here
|
|
| for RHD: If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) |
Click here
|
|
| VSC OFF indicator light abnormal (Remains on) |
Refer to VSC OFF Indicator Light Remains ON |
Click here
|
| VSC OFF indicator light abnormal (Does not come on) |
Refer to VSC OFF Indicator Light does not Come ON |
Click here
|
| Slip indicator light abnormal (Remains on) |
Refer to Slip Indicator Light Remains ON |
Click here
|
| Slip indicator light abnormal (Does not come on) |
Refer to Slip Indicator Light does not Come ON |
Click here
|
| Test Mode (signal check) cannot be performed |
TS and CG terminal circuit |
Click here
|
| for LHD: Skid control ECU (Brake actuator assembly) |
Click here
|
|
| for RHD: Skid control ECU (Brake actuator assembly) |
Click here
|