C1437 Lost Communication with ECM
Diagnostic trouble codes · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the ECM via the CAN communication system.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1437 |
When the IG1 terminal voltage is 10 V or higher and the vehicle speed is 15 km/h (9 mph) or more, data cannot be sent from the ECM for 2 seconds or more. |
|
INSPECTION PROCEDURE
- NOTICE:
- After replacing the brake actuator assembly, perform calibration (Click here).
| 1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION) |
Using the intelligent tester, check for any momentary interruption in the wire harness and connector corresponding to the DTC (Click here).
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
EFI Communication Open
ECM communication open circuit detection / Error or Normal
Normal
-
- OK:
- Normal (there are no momentary interruptions).
- HINT:
- Perform the above inspection before removing the ECUs or disconnecting a connector.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output (Click here).
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC C1437 is not output
A
DTC C1437 is output
for LHD
B
for RHD
C
CAN communication system DTC is output
D
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
| 3. REPAIR OR REPLACE HARNESS OR CONNECTOR (SKID CONTROL ECU - ECM) |
Turn the ignition switch off.
Repair or replace the harness or connector.
Check for any momentary interruption between the skid control ECU (brake actuator assembly) and ECM (Click here).
Confirm that there is no momentary interruption.
| NEXT | |
| 4. RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output (Click here).
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC C1437 is not output
A
DTC C1437 is output
for LHD
B
for RHD
C
CAN communication system DTC is output
D
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
